Start with Bending Branches’ seated method if you want a straight or bent paddle: sit upright on a flat chair, measure from the seat between your legs to the bottom of your nose, then use the matching column in its chart. A 30-inch measurement points to a 56-inch straight paddle or a 52-inch bent paddle; those are the chart’s straight and bent paddle lengths.1
Measure and choose a starting length
Sit upright on a flat, level chair. Measure from the chair seat between your legs to the bottom of your nose. Bending Branches calls this your torso length and uses it to select a full paddle length. Its chart gives these straight and bent lengths:
| Seat-to-nose measurement | Straight paddle | Bent paddle |
|---|---|---|
| 26 inches | 52 inches | 48 inches |
| 28 inches | 54 inches | 50 inches |
| 30 inches | 56 inches | 52 inches |
| 32 inches | 58 inches | 54 inches |
| 34 inches | 60 inches | 56 inches |
| 36 inches | 62 inches | No recommendation |
| 38 inches | 64 inches | No recommendation |
The shaft is the part between the grip and the throat, also called the shoulder: the junction where the shaft meets the blade. Bending Branches’ chart gives overall paddle lengths, while other methods estimate shaft length. Keep the two measurements separate when comparing recommendations.2,3
Other makers use different starting methods:
- Grey Owl Paddles: sit upright on a flat chair or the floor and measure from the seat to your chin. Add about 6 inches to estimate shaft length.2 Its example turns a 26-inch seat-to-chin measurement into an approximately 32-inch shaft. Grey Owl says a 1- to 2-inch variation can be acceptable depending on paddling style, seat height, and comfort.2
- Grass Sticks: sit upright on a hard, level chair and measure from the seat to your nose. For its custom paddles, it treats that measurement as torso and shaft length, then adds 19 inches for the blade portion added to the shaft.4 A 30-inch measurement therefore gives a 49-inch total for that method; don’t use the 19-inch addition to size another maker’s paddle.4
- REI Co-op: for its home method, kneel with your bottom about 6 inches above the floor, measure from the floor to your nose in that posture, and add the blade length.5 REI says a blade is commonly 20 inches, but use the chosen model’s blade length when you know it.6 For a bent-shaft paddle, REI says to subtract 2 inches from the length determined by its method.3
These are separate sizing systems. For instance, Bending Branches’ canoe sizing chart lists a bent-paddle length four inches shorter than its straight-paddle length in every row where both are shown, such as 52 inches straight and 48 inches bent for a 26-inch torso measurement.7 Do not also subtract REI’s 2 inches from that chart result.1,3
Adjust for your canoe and paddling position
Use the chosen maker’s advice for the canoe you paddle. Bending Branches says a narrow canoe, inward-leaning sides (called tumblehome), or a low seat can call for a shorter shaft, typically one size shorter. An extra-wide, flared canoe, or a high seat, can call for a slightly longer paddle.1
The makers also differ on position. Bending Branches gives the same baseline for bow (front), stern (rear), solo, and kneeling paddlers.1 REI suggests considering 2 inches more for a wider canoe or for paddling from the stern, so you can reach the water without leaning excessively.6 Choose one maker’s method and check the fit; don’t stack these adjustments.
Bending Branches also says to consider a longer paddle for narrow waterways such as creeks or rivers, whitewater, or maneuvering strokes. It says a shorter paddle may suit a tumblehome or sleek, narrow canoe. If both conditions apply, use the fit checks below to choose the shortest paddle that still lets you reach the water properly.1
Check the fit before buying and on the water
For Bending Branches’ chair check, sit and place the grip between your legs. The maker’s chart says the shoulder of a straight paddle should reach your hairline and the shoulder of a bent paddle should reach your nose; size up or down accordingly. Use this as a check of shoulder position, not blade-tip-to-face distance.1
In the middle of the stroke, Bending Branches says most paddlers hold the top hand about nose height and the throat or shoulder at the waterline. Choose the shortest paddle that lets you reach the water properly. REI’s on-the-water check compares the vertical distance from your nose to the waterline with the distance from a paddle’s grip to the throat; REI says the two should match.1,3 Scouting America recommends sizing your paddle in the canoe in your paddling position, sitting or kneeling, if you can.8 In The Paddler, Marc Ornstein recommends putting the equivalent trip weight in your canoe before taking the measurement in his paddle-sizing method if you commonly travel heavily loaded.9
For a store check, REI says to kneel with your bottom about 6 inches off the floor to simulate sitting in a canoe.6 Hold the paddle upside down with the grip on the floor; its throat should fall between your chin and nose. This is a fit check, not an instruction to shorten a paddle by 6 inches when you kneel on the water.3
If your measurement falls between chart rows or the size that fits your torso feels too long or short, try the adjacent size and repeat the relevant check. Bending Branches says to size up or down after its chair check. On the water, check whether you can reach the water without excessive leaning and whether the throat reaches the waterline. Before an on-water trial, ask the retailer about a demo or its return policy: Bending Branches says paddles must be unused to qualify for a return. Always carry a spare in case you lose or break your paddle.1,3,10
Compare the blade and shaft on named paddles
A paddle’s blade is its broad end in the water. In its canoe-paddle guide archived on February 3, 2026, REI calls an 8-by-20-inch (20-by-51-centimeter) blade the most common size.11 Sawyer describes its Ranger X as an expedition and whitewater canoe paddle with a modern teardrop blade profile.12 Joe O’ Outdoors describes its Ottertail as particularly well suited to deep lakes and touring, where smoothness and efficiency matter more than brute force.13 Canoeing instructor Charles Burchill’s Lake Canoe Resource describes voyageur blades as good for long day trips at a high stroke rate.14 Grey Owl describes its Voyageur canoe paddle as designed for distance, all-around tripping and steady cadence.15 Sawyer describes its Camp Canoe Paddle’s square-tip blade as designed for water conditions including shallow water.16 Aqua-Bound lists its Edge whitewater canoe paddle with a blade area of 129 square inches (832 square centimeters). The maker says each Edge model weighs 26.5 ounces (about 751 grams) and comes in lengths from 50 to 60 inches (127 to 152 centimeters), in 2-inch (about 5-centimeter) steps.17 Aqua Bound lists its Edge canoe paddle at around $159.95 (Aqua Bound’s price on its own page, as archived in August 2026) for the one-piece version and around $189.95 (Aqua Bound’s price on its own page, as archived in August 2026) for the three-piece version.18 Bending Branches lists its Explorer Plus canoe paddle at 23 ounces (652 grams).19 The table compares the listed blade dimensions and stated use of three models.
| Named paddle | Listed sizes and shaft | Blade dimensions and stated use |
|---|---|---|
| Explorer Plus | 52–62 inches; straight shaft | 8.1 × 19 inches; wilderness trips and flatwater paddling.20 |
| BB Special | 48–56 inches; 11-degree bent shaft | 8.1 × 19 inches; flatwater cruising.21 |
| Beavertail | 54, 57, 60, or 63 inches; straight shaft | 6.75 × 25 inches; designed for deep-water lake paddling, but annoying to paddle with in shallow conditions and susceptible to breakage there.22,1 |
The Beavertail’s blade is longer than the other two models’ listed blades. Bending Branches says to size up 2 to 4 inches for this paddle to account for its longer blade and shorter shaft.7 For a 30-inch torso, that suggests 58 to 60 inches overall before you check the fit and choose among the Beavertail’s listed sizes.1,22
Bending Branches says straight shafts suit all-around paddling and maneuvering, and stern paddlers often prefer them. Its bent shafts keep the blade vertical through the most powerful part of the stroke, and bow paddlers typically prefer them. These are preferences, not restrictions on who can use either style.1 Bending Branches says economical paddles are fine for trips of six hours or less and emphasizes weight, durability, and performance for trips of six hours or more or multiple days.1 Bending Branches says carbon fiber may suit canoeists looking for a lightweight paddle for long trips or racing.1
Where next
For kayak paddle length, blade, and material choices, see How to Choose a Kayak Paddle. For a SUP, see Paddle Board Paddle Sizing. Paddle Length Charts Compared covers differences among sizing charts, and the accessories guide lists more paddle accessories.
Footnotes
-
Bending Branches, How to Size & Choose a Canoe Paddle; Bending Branches canoe sizing chart. ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11 ↩12 ↩13 ↩14
-
REI Co-op Expert Advice, How to Choose Canoe Paddles. ↩ ↩2 ↩3 ↩4 ↩5 ↩6
-
Grass Sticks, How to Choose the Correct Canoe Paddle Length. ↩ ↩2
-
https://web.archive.org/web/20260203175747/https://www.rei.com/learn/expert-advice/canoe-paddle.html ↩
-
https://web.archive.org/web/20260203175747/https://www.rei.com/learn/expert-advice/canoe-paddle.html ↩ ↩2 ↩3
-
https://cdn.shopify.com/s/files/1/2236/0745/files/BB_Canoe_Sizing_Chart_2025.png?v=1742355793 ↩ ↩2
-
https://filestore.scouting.org/filestore/Merit_Badge_ReqandRes/Pamphlets/Canoeing.pdf ↩
-
https://web.archive.org/web/20260203175747/https://www.rei.com/learn/expert-advice/canoe-paddle.html ↩
-
https://paddlesandoars.com/PADDLES/CANOE-RAFT-PADDLES/ranger-x-canoe-paddle ↩
-
https://home.cc.umanitoba.ca/~burchil/pm_canoe/Lake_Canoe_Resource_pw.pdf ↩
-
https://www.aquabound.com/blogs/resources/aqua-bound-s-edge-whitewater-canoe-paddle ↩
-
Wayback Machine copy captured August 9, 2026 of https://www.aquabound.com/collections/ww-canoe ↩