Accessories

Kayak Paddle Care, Storage and When to Replace

Don’t use age alone as a reason to replace the whole paddle.

Key Takeaways

  • Check your paddle’s maker and blade material before choosing a cleaning method.
  • Rinse and dry the parts and connections according to the maker’s instructions.
  • Store the paddle dry and protect it from the heat, sunlight or freezing conditions named by its maker.
  • Ask the maker about a sticking joint, loose bolt or damage before attempting a repair.
  • Pack breakdown sections in a protective bag and keep heavy gear off the paddle.

Clean by paddle maker

The shaft is the long section you hold, connecting the blades. The shaft’s material does not tell you what the blades are made of, so check both before cleaning. A breakdown paddle comes apart into sections for carrying or storage.

Paddle or materialMaker’s care instructions
Aqua Bound paddleSeparate the halves after use; for a four-piece paddle, remove the blades too. Rinse all pieces and the ferrule with clean, fresh water. Check inside the shaft for water or debris, then drain and dry the sections with the blades tipped up. For blade washing, use warm water and mild detergent; the waxing rules below are separate.
Aqua Bound fiberglass or carbon laminate bladesOccasional waxing is permitted. Sting Ray Carbon and Fiberglass blades are reinforced nylon, classified as plastic; do not wax them. Use plain wax without additives; cleaner-and-wax products may contain abrasives, gritty ingredients that can scratch the blade.
Aqua Bound plastic bladesDo not wax them; Aqua Bound says waxing can cause hazing.
Werner Smart View adjustable ferruleTake the system apart after use and rinse with fresh water. If debris remains on the splines—the interlocking ridges at the joint—scrub them with a soft brush and fresh water or soapy water.
Bending Branches wood paddleIf the finish wears through and bare wood shows, refinish it.

Kokopelli’s care directions apply to its co-branded Werner Powerhouse four-piece paddle. After saltwater, silty rivers or muddy creeks, rinse it thoroughly with fresh water, paying attention to the connections. Dry it completely before storage.3

For Bending Branches kayak-fishing paddles, clean saltwater residue from the blades, shaft and ferrule with soapy water and a soft brush.4

Clean and check the joints

Some ferrules use splines: ridges that interlock to help the sections fit together. Remove grit with the cleaning method specified for your paddle’s joint.

Werner ferrules

For Werner Smart-View Adjustable Ferrules, do not use lubricant. If the ferrule still does not work or move smoothly after cleaning, contact Werner customer service.5

For a Werner breakdown paddle that is stuck, the maker recommends washing it with regular dish soap and warm water, then rinsing thoroughly. If it remains stuck, Werner permits soaking it in warm, soapy water for a few hours and trying to pull it apart; repeat as needed.6

Match the white alignment dots—the marks on the sections—when connecting the pieces.6

Bending Branches’ Versa-Lok joint

For Bending Branches’ Versa-Lok adjustable joint (a bolt-locked ferrule), contact customer service if you think the joint’s bolt has come loose. Do not try to adjust it yourself: the company warns that adjustments can cause stress, failure and loss of warranty coverage.7

Bending Branches’ FAQ states that its paddles are guaranteed against manufacturing defects for two years from purchase.8

Choose a storage spot

When possible, Aqua Bound recommends storing paddle halves apart in a clean, dry indoor space. After storage in a garage, shed or outdoors, check inside the shaft before using the paddle.1

Bending Branches recommends bringing paddles indoors and protecting them from freezing temperatures during winter. It advises against leaving them inside an outdoor boat or in weeds or long grass. The company recommends storing kayak paddle sections apart.2

For the Werner Powerhouse four-piece paddle sold by Kokopelli, store all four pieces disassembled in a cool, dry place. Keep that paddle away from direct sunlight and extreme heat, including heat in a car trunk or roof box.3

For a Bending Branches wood paddle, choose a dry indoor place.9

Inspect before putting the paddle away

Check the blades and shaft for cracks or substantial damage, clear debris from all parts, and check that the joint works properly. Aqua Bound describes blade delamination as the layers peeling apart and becoming susceptible to water.10

Bending Branches recommends checking ferrule operation and looking for major cracks before winter storage.2 If you find a crack or an unreliable joint, stop using the paddle and contact its maker promptly for assessment; Bending Branches says small problems can often be repaired when caught early.7

Werner Stealth and Covert recall

The U.S. Consumer Product Safety Commission’s October 30, 2025 recall notice for Werner Stealth and Covert paddles records that Werner had received 80 reports of paddles breaking during use, with no injuries reported.11 The notice says consumers with recalled paddles should immediately stop using them and contact Werner Paddles for a full refund as a check or online store credit.

It says consumers should complete the recall form and follow Werner’s website instructions to collect the refund or store credit: destroy the recalled paddle by cutting it into four equal pieces, halfway through each blade and halfway through the left and right side of the shaft, and upload a photo of the destroyed paddle.

See kayak recalls and defects for more detail.11 Check the Consumer Product Safety Commission’s recall notice for contact updates: its recall handbook says companies must immediately report changed recall contact information or recall-page addresses so the notice can be updated.12

Mergner polyamide blades

Mergner warns that repeated blows to the same spot on its polyamide paddle blades greatly increase the risk of breakage.13

Refinish exposed bare wood

On a Bending Branches wood paddle, exposed bare wood is the maker’s cue to refinish the paddle. Start with the paddle thoroughly dry. The company describes sanding the worn area, removing dust and applying two or three thin coats of oil-based polyurethane made for marine use.

Let each coat dry for several hours, and allow the paddle to dry for a few days after the final coat so it can cure.9

Wood-paddle repair or refinishing

Bending Branches offers wood-paddle repair or refinishing beyond the owner’s ability for a modest charge if the Rockgard protective strip along the blade edge has not separated from the wood.

To request an assessment and estimate, call 715-755-3405, email [email protected] with the model, approximate age, issue and helpful photos, or use the Warranty & Repairs form.9,14

For its varnished wooden paddles, Grey Owl says the polyurethane varnish is not resistant to rock abrasions and recommends lightly sanding and recoating nicks and scratches annually with a quality marine urethane varnish.15

A worn-looking tip on a new Bending Branches wood paddle may be a normal wear mark from factory finishing. The company says this appearance is normal and does not affect performance.7

Replacement parts

For a Bending Branches paddle, ask about replacement snap buttons or spring tabs if wear affects use or performance; the maker may also be able to match a lost or broken half to the surviving half.14

Aqua Bound lists worn, rusted or missing snap buttons, worn Posi-Lok spring tabs and broken or lost blades as component replacement situations. Ask Aqua Bound about the affected part; built-in Versa-Lok parts cannot be ordered as replacements, and broken parts are handled under warranty (Aqua Bound repair guidance).

Aqua Bound warns that going outside its paddle-care guidelines may void your paddle’s warranty.1 Have the maker assess damage and available repairs or parts before discarding the paddle.

Defects, repairs and warranty coverage

If your Werner paddle may have a qualifying defect, submit a claim with proof of purchase. Werner says it repairs defective paddles when possible and replaces them if repair is not possible. It provides a return authorization—a number approving shipment back to the maker—before you ship a paddle in and estimates the cost of repairs not covered by warranty.16

For a qualifying Werner defect, the maker repairs the paddle when possible and replaces it when repair is not possible. Werner’s warranty covers defects in material and workmanship for one year from the date of purchase, and Werner makes a repair determination when it receives the paddle.16

If the damage is not a defect, ask your maker whether it can be repaired. Old Town’s owner’s manual gives the original retail purchaser one year of limited warranty coverage for paddles and accessories from the original purchase date.17

Pack it for transport

For a breakdown paddle, Werner recommends a bag to help prevent parts from being lost or damaged while traveling or between uses, and recommends carrying a backup paddle in case one is needed.6 For Bending Branches kayak-fishing paddles, use cinch straps inside a bag to keep them from moving around.4

Keep heavy gear off the paddle in transport: Kokopelli gives this direction for its Werner Powerhouse paddle, and Bending Branches gives it for wood paddles in vehicles and on portages.3,9 Use those packing directions for the paddle; follow your vehicle and rack maker’s instructions for securing the kayak.

Where to go next

Use kayak paddle materials to distinguish blade and shaft construction, and paddle shafts and ferrules to compare joint systems.

For a coverage question or possible defect, see paddle warranties and recalls. If the maker’s assessment points to replacing the whole paddle, start with how to choose a kayak paddle or browse the accessories guide.

Footnotes

  1. https://www.aquabound.com/blogs/resources/caring-for-your-kayak-paddle ↩ ↩2 ↩3 ↩4

  2. https://www.bendingbranches.com/blogs/resources/paddle-storage-during-winter ↩ ↩2 ↩3

  3. https://kokopelli.com/products/werner-x-kokopelli-powerhouse-paddle-4-piece-breakdown-soca-blue ↩ ↩2 ↩3

  4. https://www.bendingbranches.com/blogs/resources/proper-kayak-fishing-paddle-care-storage ↩ ↩2

  5. https://wernerpaddles.com/pages/faq-eu ↩

  6. https://wernerpaddles.com/blogs/news/caring-for-your-4-piece-paddle ↩ ↩2 ↩3

  7. https://www.bendingbranches.com/pages/frequently-asked-questions ↩ ↩2 ↩3

  8. Wayback Machine copy captured January 7, 2026 of https://www.bendingbranches.com/pages/frequently-asked-questions ↩

  9. https://www.bendingbranches.com/blogs/resources/caring-for-your-wood-paddle ↩ ↩2 ↩3 ↩4

  10. https://www.aquabound.com/blogs/resources/lam-lok-technology ↩

  11. https://www.cpsc.gov/Recalls/2026/Werner-Paddles-Recalls-Kayak-Paddles-Due-to-Drowning-Hazard ↩ ↩2

  12. https://www.cpsc.gov/s3fs-public/RecallHandbookFINAL9_2technicalrevision_3052025.pdf ↩

  13. https://mergner-paddel.de/wissenswertes/umgang-paddel/ ↩

  14. https://www.bendingbranches.com/blogs/resources/replacement-parts-amp-repairs-for-your-bending-branches-paddle ↩ ↩2

  15. https://greyowlpaddles.com/pages/warranty-return-policy-and-paddle-care ↩

  16. https://wernerpaddles.com/pages/warranty-repairs ↩ ↩2

  17. https://johnsonoutdoors.widen.net/content/gtfkqjadpu/pdf/otc_owners_manual_web.pdf ↩