This page summarizes published safety guidance. It is not a substitute for instruction, and conditions on your water may differ. Check the current rules for the state and water you paddle.
Use these rules to choose your starting arrangement:
- If your car accepts a compatible rack, start there: Yakima requires racks authorized for the vehicle and compliance with the vehicle, rack and accessory load limits.6
- If you want temporary carrying without crossbars, check a complete rackless kit: Malone’s foam-block instructions include a bare-roof installation, while its inflatable HandiRack requires approved vehicle fit and removal when unused.3,4
- If lifting is the obstacle, arrange help or assess a loading aid: Riot recommends two-person roof loading for all but its shortest craft; Thule’s Hullavator Pro permits loading and strapping at waist height.1,7
- If you want another kayak, reassess space and weight first: Yakima’s BigStack instructions require room between the stacker and rack tower for the kayaks on edge, alongside compliance with rack weight limits.8
If you cannot establish an approved fit, adequate load allowance and a workable loading method, choose another vehicle or arrange transport before buying roof equipment.
Check your exact car and complete load
Identify your car’s model, year and roof type before selecting hardware. Distinguish crossbars—the bars running across the roof—from any rails running front to back.
For a Yakima setup, its JayLow manual requires you to follow the carrier instructions, roof-rack mounting instructions and vehicle instructions together.6 Thule likewise requires the assembly sequence and any supplied recommendation list to be followed.5
Do not assume that a glass roof, sunroof or factory rack settles compatibility. Thule permits installation on glass-roof cars unless its mounting instructions specify otherwise, but warns that some sunroofs and antennas cannot be used with the carrier fitted.5 Ask the rack maker to confirm your exact combination if the fit information is unclear.
Next, write down the weights of the kayak, bars, mounting equipment, carrier and any other roof cargo. Thule’s calculation is:
Roof load = load-carrier weight + fitted carrier accessories + cargo weight.5
Thule requires the lower applicable maximum to govern, including the car manufacturer’s roof limit.5 Yakima also prohibits exceeding the roof rack, accessory rack or vehicle manufacturer’s maximum.6 A carrier’s capacity therefore does not replace the other limits.
Measure the available crossbar spacing, then match it to the particular product. Yakima’s JayLow specifies a minimum spread of 27.5 inches (69.85 centimeters), while its BigStack specifies 24 inches (61 centimeters).6,8 Malone’s foam-block instructions say crossbars should be at least 24 inches (61 centimeters) apart when the blocks are used on bars.3
Use the requirements for your chosen equipment rather than treating one of these figures as a universal kayak spacing.
For another boat, repeat the calculation and layout check. Yakima’s BigStack instructions require straps to loop under the crossbar and normally sit inboard of the tower and note that more than two kayaks may require additional straps.8 Check the complete arrangement before committing to carrying both boats.
Choose supports and a manageable loading method
The hull is the kayak’s outer shell. Bulkheads are internal partitions.
Delta recommends positioning rack supports as close to the bulkheads as possible, using kayak cradles or foam blocks as the resting platform.2 For its fiberglass and thermoformed ABS plastic craft, Riot calls for foam padding on the rack or a padded cradle.1 Choose supports for your kayak’s construction and the carrier’s intended position.
For orientation, follow the selected kayak and carrier instructions. Riot’s multiple-kayak guidance specifies a stacking bar, suitable padding and boats on their sides with hull against hull.1 That is a particular arrangement, rather than a direction to turn every kayak onto its side.
Before transport, Riot instructs you to remove all accessories to avoid loss or damage.1 Its transport guidance recommends two people for all but the shortest craft and lifting with the legs rather than the back.1 Arrange the same help for unloading.
If you need mechanical assistance, Thule’s Hullavator Pro has extending arms that allow waist-height strapping and lower the kayak by up to 3 feet (0.91 meters).7 Confirm the aid’s current vehicle fit, bar requirements, equipment weight and kayak capacity before choosing it.
Secure a kayak on crossbars
Keep the carrier’s own strap routing with the equipment. For a kayak carried on a roof rack, NRS recommends two straps because a separate strap at each crossbar provides backup if one fails.9
NRS gives this two-strap procedure:
- Prepare one strap at each bar: NRS specifies two straps of 9 or 12 feet (2.74 or 3.66 meters), with one used at each end of the rack.9
- Make the first pass: Following NRS’s routing, pass the buckle end under the crossbar, bring both ends over the boat and leave the buckle on top.9
- Complete and tighten the loop: NRS directs you to bring the running end down under the crossbar, return it to the buckle and tighten; repeat the arrangement at the other bar.9
For strap selection, Delta specifies cam-buckle straps measuring 1 inch by 8 feet (2.54 centimeters by 2.44 meters) for its kayaks and warns against ratchet straps because they can easily be overtightened.2 A cam buckle holds the strap after you pull its loose end through. Choose the length and type required for your actual boat and carrying system.
NRS advises tension firm enough to prevent shifting, without tightening so hard that it damages composite hulls, distorts plastic boats or unnecessarily stresses the rack.9 Thule prohibits elastic bungees for securing the load.5
The bow is the front of the kayak; the stern is the rear. Yakima’s JayLow manual requires both bow and stern tie-downs, in addition to the supplied boat straps.6 If suitable vehicle attachment points are absent or the lines would damage the vehicle, Yakima requires its Hood Anchor; if that solution does not work, it directs you to contact Yakima.6
For its BigStack, Yakima specifies attachment to a metal bumper surface, tow loop or frame hole, with the boat attachment at a grab handle or rescue bar.8 Follow the attachment requirements for your own equipment rather than choosing a convenient-looking trim piece.
Delta warns against overtightening the end lines, and Yakima’s BigStack instructions require loose strap ends to be bound and tied off.2,8
Carrying without crossbars
Choose a complete system with instructions for your roof. Malone rates its Standard Kayak Kit for one kayak with a load capacity of 55 pounds (24.9 kilograms); the kit itself weighs 3.3 pounds (1.5 kilograms).3
For the bare-roof version of that kit, Malone’s instructions give this sequence:
- Prepare the contact surfaces: Malone directs you to clean the roof and block bottoms, then place the two blocks as close to the front and rear of the roof as possible.3
- Position the kayak: Malone directs you to reposition the blocks until the kayak’s weight is evenly distributed between them.3
- Route the load straps: With the doors open, Malone directs you to pass the non-buckle ends over the middle of the kayak, bring the ends together inside the vehicle, buckle them and confirm they are tight and secure.3
- Attach the end restraints: Malone directs you to attach hooks to the tie-down ropes, secure the bow line between the kayak and vehicle front, repeat at the stern, and confirm the kayak is firmly secured.3
- Recheck: Malone specifies checking the setup after 5 miles (8 kilometers).3
Use the kit’s MPG306 bow-and-stern line instructions for the hook attachment and rope knots. Malone requires bow and stern safety lines for all its rooftop transports.3
For an inflatable alternative, Malone lists the HandiRack at a load capacity of 180 pounds (81.6 kilograms), with equipment weight of 6 pounds (2.7 kilograms), and requires checking its vehicle Fit Guide.4 Keep those product figures separate from your car’s permitted roof load.
Malone warns that wet straps can carry rainwater into the vehicle and says its foam-block system should be removed from the vehicle after each use.3 Consider that limitation when choosing a setup for repeated wet journeys.
Check overhang, clearance and the drive
Measure the loaded vehicle, including the kayak’s rear projection. Check the road-load rules along your route, including marking, lighting and visibility requirements.
For a concrete state example, Washington’s RCW 46.37.140 requires red or orange fluorescent flags at least 18 inches (45.72 centimeters) square when a load projects more than 4 feet (1.22 meters) behind the vehicle or more than 4 inches (10.16 centimeters) beyond its sides.10 The statute also specifies lamps and reflectors for rear projections of 4 feet or more at the times covered by its lighting provision.10 Check that provision before planning a journey requiring lights.
Record your loaded height, as prompted in Yakima’s JayLow manual.6 Riot specifically warns about driving into a garage with the kayak still on the roof, while Yakima’s BigStack manual warns that long loads can obstruct the rear hatch.1,8
For a Thule setup, its roof-rack safety instructions set an upper limit of 80 mph (130 kilometers per hour), while requiring speed to suit the load, road, wind, traffic and applicable speed limits.5 Thule also warns that roof loads change handling and braking and increase sensitivity to side winds.5 Treat the stated maximum as a ceiling, rather than a cruising recommendation.
Check journey restrictions too: Yakima’s JayLow manual discourages off-road driving, and its BigStack instructions require removing the accessory before an automatic car wash.6,8
Inspect the installation and respond to problems
Before departure, Yakima’s BigStack instructions call for rocking the boat to test movement and retightening if it is loose.8 Thule’s rack instructions also require a push-and-pull check of the carrier, with firmer securing if any part moves.5
Plan inspection stops. Yakima’s JayLow manual calls for checks before travel, after driving a short distance following installation or loading, regularly on longer journeys, more frequently on rough terrain and after leaving the vehicle unattended.6
Respond to symptoms before continuing:
- Movement or loose straps: Stop and identify what has shifted. Yakima requires checking hardware before each use and tightening it when necessary; its BigStack instructions also require replacing worn or frayed straps.8
- Strap vibration: NRS recommends a twist in unsupported strap sections to reduce wind vibration.9
- Rainwater inside: Malone identifies wet straps as a possible route for leakage.3 Reconsider the setup before the next wet journey.
- Hull distortion: Delta warns against tightening straps until the kayak changes shape; Riot warns against leaving its craft tied down for extended periods or in hot sun.2,1 Unload and resolve the support or tension problem before the next drive.
Prepare for the water before leaving home
Pack the paddling equipment separately from the transport restraints. The U.S. Coast Guard’s FAQ states that federal requirements generally include a serviceable, appropriately sized, approved wearable life jacket for each person aboard, and recommends wearing it whenever underway.11
The American Canoe Association advises learning self-rescue, proper paddling technique and rescue skills, and avoiding weather or water beyond your skill level.12 Connecticut’s paddling checklist likewise calls for practicing safety and rescue techniques and obtaining instruction for unfamiliar equipment.13
Finally, the National Weather Service advises obtaining the latest marine forecast and warnings before setting out and planning for conditions above and below forecast ranges.14 Make the transport plan and the paddling plan work for the same trip before loading the car.
Footnotes
-
https://support.riotkayaks.com/portal/en/kb/articles/how-do-i-transport-my-kayak-on-a-vehicle-12-12-2023 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8
-
https://www.deltakayaks.com/wp-content/uploads/2018/10/2018-delta-kayaks-owners-manual.pdf ↩ ↩2 ↩3 ↩4 ↩5
-
https://maloneautoracks.com/Kayak-Carrier-with-Tie-Downs-Foam-Block-14-Tote-Packaging.html ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11 ↩12
-
https://maloneautoracks.com/HandiRack-TM-Inflatable-Roof-Rack.html?printable=Y ↩ ↩2 ↩3
-
https://www.thule.com/-/s/approved/std.lang.all/71/96/617196.pdf ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9
-
https://assets.yakima.com/product/instructions/8004073/1 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9
-
https://assets.yakima.com/product/instructions/8004041/1 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9
-
https://www.nrs.com/learn/how-to-strap-kayaks-to-car ↩ ↩2 ↩3 ↩4 ↩5 ↩6
-
https://apps.leg.wa.gov/rcw/default.aspx?cite=46.37.140 ↩ ↩2
-
https://uscgboating.org/content/frequently-asked-questions.php ↩
-
https://americancanoe.org/wp-content/uploads/documents/sei-educational_resources/ethics_conduct.pdf ↩
-
https://portal.ct.gov/deep/boating/paddling/paddlers-safety-checklists-and-equipment ↩