Care and transport

Transporting a Kayak in a Truck: Bed Extenders and Racks

Choose your carrying arrangement, confirm its fit for your truck, then secure the kayak according to the equipment instructions. Yakima’s LongArm supports a boat beyond the bed; a bed rack raises it above the bed; cab crossbars—horizontal support bars—carry it on the cab roof.1,2,3

This page summarizes published safety guidance. It is not a substitute for instruction, and conditions on your water may differ. Check the current rules for the state and water you paddle.

Key Takeaways

  • Match the equipment to your truck and carrying position.4,5
  • Follow the lowest applicable load limit.5
  • Secure the boat to its supports and the required vehicle anchors.6,7,5
  • Check local and state laws governing overhang—the part of the boat sticking past the truck—for your loaded arrangement and route.5
  • Inspect hardware and straps before departure and during travel.7,5

Choose the supports and check their ratings

A bed extender supports the projecting boat; it does not settle the legal overhang check. LongArm requires a 2-inch (51-millimeter) hitch receiver—the socket accepting the extender—and its bed-height arrangement uses an open tailgate.1

Equipment and positionPublished limit and conditions
Yakima LongArm, bed height300 pounds (136 kilograms); adds 4 feet (1.22 meters) of bed support with a 60-inch (152-centimeter) crossbar.1
Yakima LongArm, bed-rail height300 pounds (136 kilograms); use with Yakima’s BedRock bed rack or a tonneau cover (truck-bed cover).1
Yakima LongArm, cab heightUp to 165 pounds (75 kilograms), depending on roof-rack rating. Needs a LongArm Height Extension and roof rack, both sold separately.1,7
Yakima OverHaul HDHeight: 19–30 inches (48–76 centimeters); crossbars sold separately. On-road: 500 pounds (227 kilograms), counting the 69-pound (31-kilogram) system plus gear; spacing restrictions below apply. Off-road: 300 pounds (136 kilograms), also counting the 69-pound (31-kilogram) system plus gear, which leaves about 231 pounds (105 kilograms) for gear. The spacing restrictions below apply to both ratings and can lower them.2,8
Thule Xsporter Pro, numbered height setting (“position”) 15 or lower450-pound (204-kilogram) rack limit at half height (setting 15) or below. Read the numbered toothed strip on each upright beside the adjustment knob; do not estimate height from the ground.5
Thule Xsporter Pro, position 29250-pound (113-kilogram) rack limit at full height (setting 29). Confirm other positions with Thule before loading.5

Yakima’s OverHaul HD manual says the full load rating requires at least 36 inches (91 centimeters) between crossbars.8 Below that, its manual reduces maximum ratings by 40%; it separately caps the maximum at 300 pounds (136 kilograms) for 32–35-inch (81–89-centimeter) spacing. Confirm your configuration with Yakima, especially for off-road use.8

Check truck, bed, tailgate, rack and carrier limits. Thule requires including its 57-pound (26-kilogram) rack when checking bed-rail capacity—the limit for the bed’s upper edges. Count the 57-pound (26-kilogram) rack, fitted accessories and cargo against the 450- and 250-pound rack limits too. If you use two carrying systems together, follow the lower of their capacities. Roof loading includes rack, accessories and cargo; see roof load limits explained.5,7

Use Yakima’s vehicle-fit instructions or Thule’s current vehicle selector. Confirm clearance and approved accessories for your truck; cab-roof attachments are vehicle-specific.4,3,5

Yakima says crossbar spacing under 24 inches (61 centimeters) excludes boats, and boats over 14 feet (4.27 meters) need 30 inches (76 centimeters) of spacing.9 Yakima says many of its products will no longer attach when crossbar spacing goes over 42 inches (107 centimeters).9 The extension manual’s older 24-inch fallback does not replace vehicle-specific instructions or these current requirements.3,7

Secure the kayak for your arrangement

Use the installed equipment’s instructions. Old Town recommends cam straps—straps tightened through a cam buckle—and warns against ratchet straps—straps tightened with a ratchet mechanism—because overtightening can damage the kayak or weaken roof supports. Too little restraint allows movement.10

In the bed: Center the LongArm load. Buy straps separately and tie directly to its support bar, preferably, or the endcaps covering the bar ends; its upright post can also anchor a strap. Tie the boat to a solid attachment point on the truck to prevent movement toward the window. Yakima does not name a particular truck anchor for this tie. Secure loose strap ends.6

At cab height: Set the LongArm extension level with the roof crossbar. Its brace straps secure the extender, with hooks attached to the hitch-receiver loops; they are separate from boat restraints. Center the load, tie both ends, and use the endcaps for wide loads. Secure loose strap ends.7

For Yakima roof transport, use bow and stern ties—restraints at the boat’s front and back—regardless of boat length. The kayak tie-down guide explains how to choose vehicle attachment points for these ties. A load extending over the windshield needs front and rear vehicle ties in addition to rack ties. Loose racks or omitted end ties can cause serious injury or death.3,7

Thule requires provided load straps and front and rear ties to vehicle bumpers or tow hooks for long loads. Follow the full kayak tie-down guide alongside your carrier instructions.5

Check the final overhang

Before driving, use the kayak overhang and flag laws guide to check your loaded arrangement and route. Do not assume adding an extender changes where legal overhang is measured. Overhang and flag rules are set by each state, so check every state on your route. For example, Kentucky requires two red flags by day at the extremity of the projection when any part of a load projects more than 4 feet (1.2 meters) beyond a vehicle,11 and Oregon requires end-load lights in limited visibility or, at other times, a red flag or cloth at least 12 inches (30 centimeters) square when a load extends four feet (1.2 meters) or more beyond the rear of the vehicle’s bed or body.12

LongArm instructions require its supplied flag at the load’s end, secured there with the flag’s tether. Follow Yakima’s instructions for attachment. Old Town also calls for a rear flag when the kayak projects beyond the vehicle. A supplied flag alone does not confirm compliance with your route’s rules.6,7,10,5

If the arrangement cannot comply, change it or consider a kayak trailer.

Check before driving

Check the installation, boat restraints, visibility and clearance in that order.

  • LongArm: Install the safety pin; check hardware before every use and tighten as needed without overtightening. Follow the assembly instructions.6
  • OverHaul: Check the vehicle-specific maximum in its fit listing, retighten hardware as needed and lock the rack.8
  • Thule: Check bed-rail capacity and rust; protective bed liners may require modifications. Space mounting clamps at least 3 inches (76 millimeters) apart; smaller spacing reduces capacity.5 Move the mounting base if needed. Fully seat the supplied hex key—the bolt-tightening tool—to avoid stripping bolts.5
  • Roof installation: Use vehicle-authorized racks, keep Thule doors open during mounting, and do not alter the rack attachment system by drilling extra holes. Keep roof-rack parts within the roof-edge gutters—the channels along the roof sides.8,5,7
  • Load placement: Follow Yakima’s direction to distribute weight evenly and keep it low; roof loads should not substantially project beyond the rack’s supporting area. Keep Thule loads clear of the center high-mounted brake light. Check overhead branches, bridges and garages.7,5
  • Final inspection: Tighten and secure knobs, bolts, screws, straps and locks; leave none open or unlocked. Inspect straps and hardware for wear, corrosion and damage. Replace worn or missing Yakima parts with original replacements. Carry product and vehicle instructions.5,7,10

Use equipment only for its intended purpose. Xsporter Pro is not approved for off-road use, trailers or towed vehicles; LongArm and its extension discourage off-road driving. OverHaul’s off-road approval covers moderate-speed travel on nontechnical forest-service or access roads, excluding rock crawling, jumping and bogging. Other accessories’ restrictions still apply.5,6,7,8

Recheck during the trip

Follow load-appropriate speeds and road limits; avoid sudden maneuvers and account for strong winds and changed handling. The extension manual’s 80-mile-per-hour (130-kilometer-per-hour) ceiling applies only where speed limits are absent, not as a travel target.7,5,10

Recheck after installation and a short drive: the extension specifies 30 miles (48 kilometers) or 30 minutes. Check regularly on longer trips, more often on rough terrain, and at stops—including after leaving the truck unattended. Remove racks before automatic car washes; Yakima also directs removing unused racks.7,8,5

For another arrangement, compare kayak roof racks, or return to the care and transport guide.

Footnotes

  1. https://yakima.com/products/longarm ↩ ↩2 ↩3 ↩4 ↩5

  2. https://yakima.com/products/overhaul-hd ↩ ↩2

  3. https://yakimasupport.zendesk.com/hc/en-us/articles/115005914787-Roof-Rack-101 ↩ ↩2 ↩3 ↩4

  4. https://yakimasupport.zendesk.com/hc/en-us/articles/360044754231-Fits-how-to-see-what-will-work-with-your-car ↩ ↩2

  5. https://www.thule.com/-/s/approved/std.lang.all/53/49/455349.pdf?rev=9.2 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11 ↩12 ↩13 ↩14 ↩15 ↩16 ↩17 ↩18 ↩19

  6. https://assets.yakima.com/product/instructions/8001149/4 ↩ ↩2 ↩3 ↩4 ↩5

  7. https://assets.yakima.com/product/instructions/8001150/1 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11 ↩12 ↩13 ↩14

  8. https://assets.yakima.com/product/instructions/8001151/1 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7

  9. https://yakimasupport.zendesk.com/api/v2/help_center/en-us/articles/115005914787.json ↩ ↩2

  10. https://oldtownwatercraft.johnsonoutdoors.com/us/blog/how-to-transport-kayak ↩ ↩2 ↩3 ↩4

  11. https://apps.legislature.ky.gov/law/statutes/statute.aspx?id=6303 ↩

  12. Wayback Machine copy captured September 23, 2026 of https://www.oregonlegislature.gov/bills_laws/ors/ors815.html ↩