Safety

Lining and Tracking a Canoe: What It Is and How It Works

This page summarizes published safety guidance. It is not a substitute for instruction, and conditions on your water may differ. Check the current rules for the state and water you paddle.

Use these choices before committing to a section:

  • If the water is uncertain, choose the carry. The Pennsylvania Fish and Boat Commission advises portaging—carrying your boat overland—around water you are uncertain of.2
  • If the maneuver exceeds your present skills, arrange instruction or change the route. The ACA recommends practicing in safe conditions with instructors or expert paddlers and returning to shore when conditions feel uncomfortable.1
  • If the route requires wading, assess that separately from handling the boat. NPS Big Bend warns that river bottoms can be rocky, slippery or murky; NPS Canyonlands warns against standing in fast-moving water because a trapped foot can allow the current to push you underwater.5,6
  • If the passage involves an obstruction, plan a bypass. The Oregon State Marine Board advises portaging around obstructions and staying away from logjams.7
  • If the bank route crosses private land, settle access first. Oregon’s Department of State Lands distinguishes rights on Oregon-owned waterways from more limited bank use on other waterways navigable for public use.8

What lining and tracking mean

Think of the task as moving a floating canoe with ropes while someone travels outside it. In the Nebraska Game and Parks Commission’s June 1972 article, How To: Canoe A River, “tracking” means taking a canoe upstream with one or both canoeists walking along the bank holding ropes.3

Do not rely on the word “lining” to tell you the direction. Yellowstone’s NPS Boating Safety and Regulations uses it for walking upstream through the Lewis River Channel with the boat following behind.4 At Big Bend, NPS advises scouting problem areas and considering lining.5

For planning, describe the actual operation: upstream or downstream, walking on the bank or wading, and where the canoe needs to finish. Ask an instructor to work through that exact situation.

The Nebraska account is a historical explanation, published in 1972.3 Treat it as background for understanding the mechanics, then have the arrangement checked for your canoe and intended river section.

How upstream tracking works

The Nebraska article describes two ropes attached through low pulling arrangements called bridles, one near each end of the canoe.3 A bridle is a rope arrangement that establishes where the pull acts on the boat.

In that account, either one or both canoeists walk upstream along the bank with rope in hand; allowing slack lets the canoe drift away from the bank into the current, and walking advances it upstream.3 The article describes the front bridle shifting until the pull stabilizes against the side of the canoe.3

The pulling point is central to the explanation. The Nebraska article places it at or near the keel and warns that towing from the high bow and stern eyes can upset the canoe, describing those eyes as mooring devices.3 Mooring means securing a boat in place.

For your own boat, ask the maker which fittings can take the intended pull. Have an instructor demonstrate the complete arrangement, including controlling the canoe’s angle, passing obstacles and bringing it to the finishing point. Do not treat the historical description as permission to load any particular seat, crossbar or handle.

For downstream handling, request a separate demonstration. Include where each person stands, which line controls each end, how an obstacle is bypassed and how the canoe is secured at the finish. Until you can carry out that whole passage under instruction, choose a portage or another route.

Ropes, attachment points and load

How long bow and stern lines should be

Two published examples give different lengths for different jobs.

For upstream tracking, the Nebraska article specifies two nylon ropes, each about 50 feet (15.2 meters) long and ¼ inch (6.4 millimeters) in diameter.3 For Yellowstone’s particular upstream Lewis River passage, NPS says having at least 15 feet (4.6 meters) of rope makes lining easier.4

Keep those figures attached to their examples. Ask your instructor to select the working lines for your boat and practice section before buying or cutting rope.

A painter is a rope attached to a boat’s end. In its river-safety guidance for Canyonlands, NPS recommends that open canoes have securely anchored bow and stern painters of 8–10 feet (2.4–3 meters), stored so they remain accessible without coming loose accidentally.6 That recommendation concerns accessible boat-handling lines in the park’s equipment guidance, rather than the upstream tracking arrangement in the Nebraska article.6,3

For rope management, the Pennsylvania Fish and Boat Commission directs paddlers to keep painters and other ropes coiled and secured and never tie a rope to themselves or another paddler.2 NPS Canyonlands also identifies loose ropes as an entanglement hazard and calls for effective storage of rope systems.6

Bridle and attachment checks

The Nebraska account routes each bridle beneath the canoe and through the seat area, using a taut-line hitch and positioning the pulling point low on the boat.3 A thwart is a crossbar connecting the canoe’s sides.

Before attempting that arrangement, ask the maker to identify suitable attachment locations on your model. Then ask the instructor to demonstrate the knot, its position under load and how the working line is handled. Make those checks specific to the canoe you will use.

Load and trim

Trim means the canoe’s front-to-back balance. Wenonah’s Canoe Owner’s Manual explains that moving gear changes trim and that an end sitting too high can be pushed off course by wind.9 Its discussion concerns canoe control and wind; use it to understand balance rather than to choose a rope-handling setup.9

NPS Canyonlands advises knowing your craft’s carrying capacity and how added loads affect handling in whitewater.6 Ask the maker for the capacity before loading gear, and include the intended load in your instructor’s assessment.

Personal equipment and cold water

The US Coast Guard urges everyone aboard to wear an approved life jacket while underway, explaining that accidents can happen too quickly to retrieve a stowed one.10 The ACA advises a snug, comfortable fit that does not lift when the jacket is pulled upward at the shoulders.1

For work around cold water, the National Weather Service (NWS) advises wearing a life jacket in and around the water and dressing for water temperature rather than air temperature.11 NWS warns that sudden cold-water immersion can trigger involuntary gasping and rapid breathing, increasing drowning risk even for confident swimmers.11

Yellowstone illustrates why the specific passage matters. NPS describes cold-water wading over a rocky bottom in the northern part of the Lewis River Channel, with early-season current and later-season shallows preventing upstream paddling there.4 For June and early July, its guidance describes extremely cold water and depths of 3–4 feet (0.9–1.2 meters), and suggests considering a wetsuit.4 Those are descriptions of that passage and season, not conditions to use as a general wading limit.

For footwear, the Pennsylvania Fish and Boat Commission recommends wading shoes or tennis shoes with wool, polypropylene, pile or neoprene socks.2 NPS Big Bend advises stepping where you can see your footing when possible.5

When to stop or choose another route

A strainer is an obstruction that lets water pass through while blocking larger objects. NPS Canyonlands warns that brush, fallen trees and undercut rocks can pin boats and people, including in current with little or no whitewater as a warning.6 Oregon’s State Marine Board warns that logjams can sweep people and equipment underneath them.7

Choose the bypass before reaching those obstacles. The Oregon State Marine Board advises going ashore well upstream to scout rapids and portaging dangerous sections when possible.7 The Pennsylvania Fish and Boat Commission says never to take a boat over a low-head dam.2

For changing conditions, the ACA advises checking river levels, maintaining an exit strategy and getting off the water when weather changes for the worse.1 NPS Canyonlands warns that rising flows increase river power and make rescue harder.6

Access also needs a complete route. Oregon’s Department of State Lands allows public use of beds and banks of Oregon-owned waterways up to ordinary high water, while describing different rights on waterways that are navigable for public use but have not been determined to be Oregon-owned.8 Above ordinary high water, access onto private property is limited to brief use when necessary to lawful waterway use, with examples including going around an obstruction.8

Check the applicable local access rules for the entire walking section. If permission or a usable bank route remains unresolved, choose another passage.

If the canoe turns, catches or swamps

For loss of control, use NPS Canyonlands’ planning standard: your skills should let you stop or reach shore before danger.6 Make the stopping point and escape route part of the practice session.

If the boat catches sideways, NPS Canyonlands warns that strong current can collapse or wrap a canoe against a rock and that freeing pinned boats can be dangerous.6 Wenonah likewise describes a water-filled hull wrapping when current presses it sideways against an obstacle.9

For rescue priorities, NPS Canyonlands puts people before equipment and says boats and gear should be recovered only when that can be done safely.6 It also states that using rescue lines requires training.6 Arrange that training before making boat recovery part of your plan.

For an unplanned swim, the Pennsylvania Fish and Boat Commission advises keeping your feet up in current and swimming toward shore; it advises holding the boat unless doing so presents a life-threatening situation.2 NPS Canyonlands warns against trying to stand in fast-moving water and advises reaching slow or very shallow water before standing or walking.6

What to arrange before your first attempt

Book instruction that explicitly covers lining and upstream tracking. Ask to practice the whole operation: inspecting the passage, selecting attachments, arranging the load, managing both lines, stopping, finishing and responding to a lost boat.

The ACA recommends learning with instructors or expert paddlers in safe conditions.1 For whitewater preparation, the Oregon State Marine Board emphasizes developing knowledge and skills before attempting unfamiliar waterways and advises never boating alone.7

Before leaving, follow the ACA’s float-plan guidance: tell a trusted person who is going, your launch and takeout, the route, expected return and what to do if you fail to check in.1 NWS also advises checking weather and water temperature before going onto the water.11

Choose instructed practice first. For a trip already ahead of you, use the Pennsylvania Fish and Boat Commission’s advice to carry around uncertain water as the fallback.2 If neither the water passage nor the carry is workable, change the route.

Footnotes

  1. https://americancanoe.org/wp-content/uploads/documents/sei-educational_resources/beginners_guide_to_safer_pad.pdf ↩ ↩2 ↩3 ↩4 ↩5 ↩6

  2. https://www.pa.gov/agencies/fishandboat/boating/paddlesports/safety ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7

  3. https://archives.outdoornebraska.gov/s/nebraskaland/item/1141 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10

  4. https://www.nps.gov/yell/planyourvisit/upload/boatingregulations_2026-9-29.pdf ↩ ↩2 ↩3 ↩4 ↩5

  5. https://www.nps.gov/bibe/planyourvisit/riversafety.htm ↩ ↩2 ↩3

  6. https://www.nps.gov/cany/planyourvisit/riversafety.htm ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11 ↩12

  7. https://www.oregon.gov/osmb/Pages/Propulsion-Landing-Pages/Go-Rivers.aspx ↩ ↩2 ↩3 ↩4

  8. https://www.oregon.gov/dsl/waterways/Pages/public-use.aspx ↩ ↩2 ↩3

  9. https://cdn.shopify.com/s/files/1/0768/3289/9308/files/WC_owners_manual.pdf?v=1781630629 ↩ ↩2 ↩3

  10. https://www.uscgboating.org/recreational-boaters/index.php?m=rb ↩

  11. https://www.weather.gov/safety/coldwater ↩ ↩2 ↩3