Accessories

Dry Bags for Kayaking: Sizes, Closures and What Owners Report

Use these Well Paddled decision rules to narrow your choice:

  • If the bag goes inside a hatch, start with a flexible model. Sea to Summit lists its 70-denier Lightweight Dry Bag for paddling and fitting into awkward spaces.4
  • If it rides exposed, choose tougher construction and attachment points. The maker lists abrasion-resistant 420-denier nylon and multiple lash points on its Big River Dry Bag.5
  • If immersion protection matters, choose by the exact closure and stated conditions. ORTLIEB’s DUFFLE meets its listed IP67 conditions only with the zipper completely closed.6
  • If your packed bag cannot close properly or fit the boat, split the contents before buying a larger sack. NRS recommends smaller bags for weight distribution and access.2

Choose sizes around your actual contents

Treat trip length as a starting point, then lay out what you intend to carry. Sea to Summit groups small essentials into 1–3-liter bags, clothing or food into 5–13-liter bags, and bulkier items such as sleeping bags into 20–65-liter bags.7

Try these worked shopping plans. They are proposed combinations, not promises that your equipment will fit:

  • Day trip: two bags, 13 liters total. Try a 10-liter bag for your layer and snacks, plus a separate 3-liter bag for small essentials.
  • One night: five bags, 54 liters total. Keep that day setup; add a 20-liter bag for sleeping gear, a 13-liter clothing bag and an 8-liter food bag.
  • Several nights: six bags, 62 liters total. Start with the overnight arrangement and try another 8-liter food bag before replacing everything with one large sack.

These examples follow the makers’ contents-based sizing and NRS’s recommendation to divide camping gear among smaller bags.1,7,2 Test-pack your tent, sleeping pad, cooking equipment and water alongside the proposed bags before treating the plan as complete.

Choose the sleeping-gear bag from its packed volume. Sea to Summit explains that sleeping bags with the same temperature rating can occupy different volumes because their insulation and fabrics differ.8 Look up your sleeping bag’s packed volume, then try it in the proposed dry bag with enough room left to close the top.

For compressible bedding, consider a compression model. Sea to Summit lists four compression straps and an air-permeable base on its Evac Heavy Duty Compression Dry Bag, allowing air to escape without a purge valve.9 Its maker still advises avoiding submersion because water can seep through the roll-top.9

Match fabric, seams and weight to the storage position

Denier, abbreviated D, describes yarn weight rather than finished fabric thickness. Check the coating, seam construction and closure alongside that number.

For protected storage, favor flexibility and low weight. For exposed storage, prioritize the maker’s abrasion claims, reinforced areas and attachment points. Sea to Summit distinguishes its pliable 70-denier Lightweight construction from the tougher 420-denier Big River construction.4,5

The table records what each maker lists:

BagFabric and seamsClosureListed empty weight
Sea to Summit Lightweight Dry Bag, 13 litersPolyurethane-coated 70-denier nylon; double-stitched, fully taped seamsRoll-top2.9 ounces (81 grams)4
Sea to Summit Big River Dry Bag, 13 liters420-denier nylon with thermoplastic polyurethane lining; reinforced, double-stitched, tape-sealed seamsRoll-top6.8 ounces (192 grams)5
NRS Tuff Sack, 10 litersPVC-free 18-ounce TobaTex; welded seamsFold-down StormStrip0.60 pounds10
NRS Ether HydroLock Dry Bag, 10 litersDual thermoplastic polyurethane-coated 70-denier nylon; welded seamsHydroLock zip seal plus fold-down StormStripNot listed11

Here, PVC means polyvinyl chloride; thermoplastic polyurethane is commonly shortened to TPU. Do not treat a material name alone as a protection rating.

Choose carrying features separately from water protection. Sea to Summit lists an optional shoulder sling for compatible Big River bags from 5–35 liters, while ORTLIEB lists removable padded shoulder straps on the DUFFLE that also serve as carrying handles.5,6 If you regularly carry gear between a parking area and the launch, include that carrying arrangement in your comparison.

Choose a closure by exposure, not appearance

An ordinary roll-top remains the starting choice for clothing and general gear stored in the boat. Sea to Summit describes its roll-top bags as suitable for keeping gear dry inside a boat, while warning against holding the closure underwater.7

Do not assume every zipped bag offers the same protection. NRS lists the Ether HydroLock as submersible with its combined zip seal and folding closure.11 Ask the maker for the depth and duration suitable for your intended use before choosing it for prolonged immersion.

ORTLIEB lists the DUFFLE’s TIZIP zipper and IP67 protection: dustproof, with temporary immersion protection at 39 inches (1 meter), measured at the product’s lower edge, for 30 minutes when completely closed.6 Its outer zippered mesh pocket is explicitly listed as not waterproof.6

Read ratings compartment by compartment. OverBoard lists its 20-liter Kayak / SUP Deck Bag’s main compartment as IP66 and suitable for “quick submersion,” but lists the outer zip pocket as IP65 weatherproof.12 In its help guidance, the maker defines quick submersion as brief accidental immersion followed by retrieval; it says the outer pocket is not submersible.13 Choose the main compartment for water-sensitive contents rather than relying on that pocket.

Hydrostatic head is a fabric-pressure measurement. Sea to Summit lists a 10,000-millimeter hydrostatic head for its Lightweight fabric while separately warning that water can enter through the roll-top during submersion.4 Do not read the fabric figure as the finished bag’s underwater limit.

Give electronics their own enclosure

Choose separate electronics protection before deciding where the outer bag goes. Sea to Summit recommends an IPX8-rated case inside a Lightweight or heavier dry bag, and calls a hard case with an O-ring seal the safest choice for seriously wet conditions or for very expensive camera gear.8

The maker lists its TPU cases as tested at a water pressure equivalent to a depth of 10 meters (about 33 feet) for up to 1 hour when properly closed, but says they are not designed for intentional submersion and that the rating does not guarantee the device itself will withstand that pressure.8

Condensation also matters: Sea to Summit explains that trapped moisture vapor can turn to liquid when a sealed enclosure cools, and recommends silica gel with electronics.3

Check the closed bag against your kayak

Measure the hatch opening—the opening into an enclosed storage compartment—and the space beyond it. Then compare the bag’s closed, packed shape with both.

For example, NRS lists the 10-liter Tuff Sack at 7.5 inches in diameter by 13.75 inches high (19 by 35 centimeters), filled and rolled.10 Use that as a shopping reference, then try the actual load through your hatch before committing to the size.

NRS advises putting heavier camping items low and centered, with lighter clothing and sleeping gear toward the ends; it also notes that most kayak hatches are water-resistant rather than watertight.2 Keep using the dry bags inside the compartments.

For deck storage, use the bag’s designated attachment points. Sea to Summit identifies the buckle D-ring and Big River’s side rails as securing points.7 NRS instructs users to position its Taj M’Haul deck bag accessibly and secure it to deck lines using the supplied arrangement.14

Test a proposed behind-the-seat position with the bag packed. Sit normally, move your paddle through its stroke and check access to the items you intend to retrieve. Reject any position that obstructs your movement.

For hatch maintenance, continue with kayak hardware and hatches.

Pack, close and test before the trip

  1. Sort by use. Separate sleeping gear, clothing and cooking supplies, then label or color-code the bags as NRS recommends.2
  2. Leave room for the closure. Remove contents if necessary. OverBoard warns against overstuffing because it stresses seams and zips.13
  3. Follow the particular closure instructions. NRS specifies folding its top-loading closure at least three times, firmly against the contents where possible, then fastening it.15 OverBoard specifies rolling its deck-bag neck tightly over the plastic fastener three or four times before clipping it shut.12
  4. Run a water check without valuable contents. Follow any test instructions supplied with your model. For an ordinary roll-top, put dry scrap cloth inside, close it, splash the exterior, dry the outside and inspect the cloth. Keep the check within the maker’s stated exposure limits.
  5. Test the packed boat. NRS recommends test-packing and taking a short paddle to adjust the load’s balance.2

For an airtight zippered model, use its maker’s test. YETI recommends fully closing the Panga zipper, applying pressure and listening for escaping air; if it leaks, check closure and repeat, then seek warranty help if the leak persists.16

If your check leaves the cloth damp, empty and dry the bag, inspect the closure and seams, and repeat the closing procedure. Pause use with valuable contents until the bag passes the check or has been repaired or replaced.

Afterward, follow the model’s care instructions. NRS recommends freshwater rinsing and air drying; YETI additionally specifies zipper cleaning and lubrication for the Panga.15,16

What counted owner reviews tell you to check

Based on published customer reviews, which we do not independently verify for authenticity.

170 of 2,067 owner reviews of dry bags mention problems with construction or finish, so fill-test the bag at home and inspect its seams and closure before the first trip (owner reviews, not a rate for all buyers); adjusted for the extra one- and two-star reviews in our collection, it is about 4 in 100.17

Use the maker’s approved method for any fill-test. Check seam edges, coating, buckles and the complete closure before packing real gear.

86 of 2,067 owner reviews of dry bags say the product arrived damaged, so unpack and inspect the bag the day it arrives, while you can still return it (owner reviews, not a rate for all buyers); adjusted for the extra one- and two-star reviews in our collection, it is about 2 in 100.18

Keep photographs of any damage and the purchase record. Use these findings to prompt inspection, rather than to predict your bag’s lifespan.

Where next

Use the kayak accessories guide for the rest of your setup, kayak weight capacity explained when planning the complete load, and required paddling gear for equipment requirements.

Footnotes

  1. https://www.yakattack.us/10l-hd-roll-top-drybag-with-air-valve-black-carbon/ ↩ ↩2

  2. https://www.nrs.com/learn/multiday-kayak-trips ↩ ↩2 ↩3 ↩4 ↩5 ↩6

  3. https://seatosummit.com/blogs/adventure-tips/packing-electronics ↩ ↩2

  4. https://seatosummit.com/products/lightweight-dry-bag ↩ ↩2 ↩3 ↩4

  5. https://seatosummit.com/products/the-big-river-dry-bag?variant=42043827847341 ↩ ↩2 ↩3 ↩4

  6. https://downloads.ortlieb.com/datasheet/en/duffle.pdf ↩ ↩2 ↩3 ↩4

  7. https://seatosummit.com/collections/dry-bags ↩ ↩2 ↩3 ↩4

  8. https://seatosummit.co.uk/pages/product-faqs ↩ ↩2 ↩3

  9. https://seatosummit.com/products/evac-compression-dry-bag-hd?variant=42126661648557 ↩ ↩2

  10. https://www.nrs.com/nrs-tuff-sacks/phb6 ↩ ↩2

  11. https://www.nrs.com/nrs-ether-hydrolock-dry-bag/p983 ↩ ↩2

  12. https://www.over-board.com/products/waterproof-kayak-deck-bag-20ltr-yellow ↩ ↩2

  13. https://www.over-board.com/pages/help ↩ ↩2

  14. https://www.nrs.com/nrs-taj-mhaul-deck-bag/pkv2 ↩

  15. https://www.nrs.com/learn/seal-nrs-dry-bag ↩ ↩2

  16. https://uk.yeti.com/pages/panga-faq ↩ ↩2

  17. Well Paddled owner-review count, figure 7151 (October 2026 count). Method: https://wellpaddled.com/about/owner-review-counts/ ↩

  18. Well Paddled owner-review count, figure 82 (October 2026 count). Method: https://wellpaddled.com/about/owner-review-counts/ ↩