Kayak fishing

Saltwater Kayak Fishing: What Makers Say to Rinse, Lubricate and Replace

Use these rules to choose the next action:

  • If the hull is just salty, start with water. Perception and Eddyline describe a fresh-water rinse as usually sufficient for routine hull cleaning.2,3
  • If steering or foot controls feel gritty, choose cleaning first. Perception directs owners to scrub grit from moving rudder or skeg parts before coating them with a silicone-based lubricant.2
  • If you have a pedal drive, choose its own maintenance instructions. The Hobie Outback manual identifies Hobie Multi-Lube for MirageDrive maintenance; Old Town’s PDL guide permits Bel Ray marine lubricant on its gears.4,1
  • If a storage compartment is wet, find the entry point before choosing a sealant. Perception identifies hatch covers, bulkhead seals and broken or loose deck fittings as checks for this problem.2
  • If you use a NOCQUA battery, keep it out of the hull-rinsing job. NOCQUA’s Pro Power battery guidance describes the battery as water resistant, prohibits immersion and calls for wiping the exterior after wet or saltwater use.5

After each saltwater trip

Make the rinse part of putting the boat away. Old Town’s PDL Drive guide specifies rinsing exposed metallic components “upon return,” while Perception recommends thoroughly rinsing gear after any saltwater use, especially before storage.1,2 Perception explains that salt attracts moisture, corrodes metal parts and can leave abrasive crystals in fabric.2

The hull is the boat’s outer shell. Start there, then give the fitted equipment its own attention rather than treating the visible shell as the whole job.

Hull, seat and steering: Wilderness Systems’ owner’s manual calls for fresh-water rinsing of the rudder, rudder cables, footbraces and seat system after saltwater use.6 A rudder is the movable steering blade; footbraces are the supports against which you rest your feet.

Foot-control rails: Eddyline’s Kayak Care and Repair page directs owners to check that the foot pedals move freely and hose sand or mud from the rails when necessary to prevent sticking and abrasion.7 For accessory tracks—the channels holding fishing mounts—follow the track and mount maker’s care instructions.

Hatches and interior: A hatch is an access opening with a removable cover. Eddyline recommends keeping its cover and rim free of sand, rinsing the cockpit after use and wiping enclosed storage compartments with a damp cloth.7 Its Carbonlite Owner’s Manual also warns that a hatch tether trapped beneath the seal creates a leak path.8

Drive: The Hobie Outback manual calls for thorough rinsing because excessive sediment can impair the MirageDrive’s forward/reverse function.4 Old Town’s PDL guide includes salt-exposed drive metal in its fresh-water rinse instruction.1

A scupper is a drainage opening through a sit-on-top kayak. Keep scupper plugs and the hull’s drain plug on your inspection list, but check the model manual before removing plugs, valves or fittings. Ask the maker to identify the correct replacement if a plug is damaged or missing.

For drainage, follow the boat’s arrangement. Eddyline describes placing its kayak upside down on sawhorses and hosing through the cockpit so dirt and excess water run out; its enclosed compartments receive a damp-cloth wipe instead.7 Do not turn that cockpit-cleaning method into an instruction to flood every boat’s storage compartments.

For closer attention to fittings, use Kayak Hardware and Hatches. Keep the separate Clean, Drain, Dry After Paddling checklist alongside your equipment-care routine.

Choose cleaners and lubricants by component

Use a fresh-water rinse as your starting point, then choose a treatment for the material or mechanism that needs it. Perception approves mild soap and water for its polyethylene kayaks; Eddyline permits a light soap solution for dirtier boats.2,3 Polyethylene is a type of plastic.

If you are choosing a dish soap such as Dawn, ask your kayak maker to confirm that exact product. Otherwise, choose the mild-soap category or named cleaner your maker approves.

ComponentMaker-approved choiceRestriction or next check
Perception polyethylene hullMild soap and water; 303 Protectant or a similar plastic protectantPerception advises against sanding or abrasive rubbing compound for routine superficial scratches.2
Eddyline kayak exteriorLight soap solution; Mer-Maid Boat Wash with Carnauba Wax for combined washing and waxingEddyline prohibits acetone, strong solvents and ammonia-based cleaners.3
Perception touring-kayak rudder or skeg moving partsScrub away grit, then coat with silicone-based lubricantCheck that moving parts are not binding.2
Old Town PDL Drive gearsA small amount of Bel Ray marine lubricant to coat the gears, accessed through the round inspection capFollow the PDL guide’s lubricant instruction for this drive.1

For a Hobie MirageDrive, use the Outback Manual maintenance page, which identifies Hobie Multi-Lube and gives a cable-tension check.4 Keep that instruction specific to the drive rather than extending it to hatch seals or electrical contacts.

For Eddyline rubber hatch covers, the maker recommends products such as 303 Aerospace Protectant and treatment at least annually, more often with strong sun exposure or outdoor storage.3 Eddyline explains that aging rubber covers can dry out, become less supple and grow harder to fit.3

Keep hull-care products away from your fish-finder screen. Garmin’s ECHOMAP UHD Owner’s Manual warns that ammonia harms the screen’s anti-reflective coating and that the coating is sensitive to waxes and abrasive cleaners.9 Its complete cleaning method is to apply an eyeglass lens cleaner approved for anti-reflective coatings to a cloth, then gently wipe with a soft, clean, lint-free cloth.9

Use Kayak Cleaners and Protectants and Kayak Care by Material for more material-specific choices.

Decide what needs adjustment, replacement or service

Build your replacement list around inspection findings.

Replace worn lines and cords. Perception directs owners to replace shock cord and static lines that are too loose or frayed.2 Shock cord is elastic cord; static line does not stretch. Eddyline also calls for inspecting bungees, perimeter lines and carry handles for wear and secure attachment, with replacement when worn out.3

Address damaged metal promptly. Old Town’s PDL guide calls for prompt attention to abrasions, nicks and gouges on metallic or powder-coated surfaces, and tightening components that are loosening from their factory condition.1 Ask the maker or dealer to assess corrosion or damaged hardware before deciding between repair and replacement.

Treat stiffness and looseness as different checks. For the Hobie Outback’s MirageDrive, the manual says cables should allow only slight inward movement under firm finger pressure.4 Loose kick-up fins have a separate set-screw adjustment in the same manual.4 Use those model-specific checks before ordering parts or changing adjustments.

Trace leaks before replacing a hatch. Perception recommends checking the cover, bulkhead seals and deck fittings first, and lists replacement deck fittings and neoprene washers for deck leaks.2 A bulkhead is an internal wall separating compartments. For an Eddyline leak repair, its FAQ recommends 3M Marine Adhesive Sealant Fast Cure 5200 or Sikaflex-291 and advises against silicone sealants.3

Do not assume a plug is compatible because it looks similar. Match the boat model and parts diagram, then confirm fit with the maker. For example, Perception’s CRANK 10 replacement sheet lists drain plugs as part 9800368, the rudder cable swivel kit as 9800695, and the pedal-drive scupper flap kit as 9800951.10 The sheet cautions that not every model includes every illustrated part.10

For a replacement Old Town PDL propeller, choose the maker’s replacement route: its guide states that an aftermarket propeller voids the warranty.1 Use Kayak Repair by Material for repair planning and Fishing Kayak Rigging when inspecting added equipment.

Give electronics and batteries separate care

Fish finders and connectors

For the STRIKER Cast, Garmin gives a complete cleaning routine: remove water and residue with a clean cloth dampened with fresh water, use mild detergent for heavy salt buildup or stains, wipe dry, and allow the device to dry completely.11 Garmin’s STRIKER Cast manual requires thoroughly cleaning and drying the contacts and surrounding area before charging or connecting to a computer because moisture can cause corrosion.11

For an ECHOMAP UHD, Garmin directs owners to cap unused connectors to prevent corrosion.9 On the ECHOMAP UHD 70/90 connection arrangement, the manual also calls for fully inserting the cable connector and tightening its locking ring.9 The memory card, gasket and door must be thoroughly dry before the door is closed.9

Use the instructions for your exact unit. For mounting and power-system planning, see Fish Finders on a Kayak.

NOCQUA batteries

NOCQUA’s Pro Power battery guidance calls for a lightly damp exterior wipe after wet or saltwater use, thorough drying, dry ports and connections, and disconnection from accessories when unused.5 It also recommends its Corrosion Preventative Kit for saltwater use and inspection of cables, caps and connectors for moisture, corrosion or damage.5

For charging its batteries, NOCQUA specifies a dry, well-ventilated place away from flammable materials, supervision throughout charging and disconnection when charging finishes; it also recommends a fire-resistant lithium battery charging bag.5

NOCQUA directs owners to stop using or charging a battery that is swollen, leaking, unusually hot, producing an unusual odor or physically damaged, and to contact customer support.5 NOCQUA also prohibits opening, puncturing, crushing or modifying the battery.5

Before storage and before the next season

Before seasonal storage, finish cleaning and inspect the parts above. Add battery storage to the list separately:

  • NOCQUA batteries: NOCQUA specifies about 40–60% charge for storage lasting several weeks or longer, indoors and dry at about 50–77°F (10–25°C), with charge checks every two to three months.5
  • Garmin STRIKER Cast: Garmin specifies at least 50% charge before storage lasting several months, a cool, dry location around household temperature, and a full recharge before use.11

Choose hull supports using your boat’s manual. For the Outback, Hobie permits upside-down storage on crossbars or suspension from wide straps and warns against hanging the boat by its scuppers, handles or pad eyes.4 Old Town’s PDL guide says the drive unit should be kept inside.1

For outdoor Eddyline storage, the maker recommends elevating and covering the kayak, securing it against wind damage and storing it clean and dry.3 Eddyline also warns that prolonged sunlight eventually degrades Carbonlite despite its ultraviolet resistance, and that freezing water can put stress on seams and glue joints.3 For the Hobie Outback, Hobie limits time on a transport cart to one hour, with less time in warm temperatures or direct sunlight.4

Use How to Store a Kayak and Kayak Covers to choose the storage arrangement; use Winterizing a Kayak for the broader seasonal list.

On return to use, repeat the mechanical checks rather than relying on the last trip’s condition. Old Town’s PDL guide calls for clearing debris around the propeller, checking secure propeller hardware, inspecting and tightening rudder hardware and cables, and testing drive function on land before launching.1 The Hobie Outback manual calls for checking equipment for wear or failure before every use.4

Where next

Keep this page as your combined boat, drive and electronics checklist. For propulsion choices, continue to Pedal Drives Compared; for the wider setup, use Kayak Fishing: Boats, Drives, Rigging and Rules.

Footnotes

  1. https://johnsonoutdoors.widen.net/content/ru0odhajut/pdf/OT_productmanual_PDL_Drive_Guide.pdf ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9

  2. https://www.confluenceoutdoor.com/pages/perception-faq ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11

  3. https://eddyline.com/pages/faqs ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9

  4. https://media.hobie.com/digital_assets/Outback_Manual_2021.pdf ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8

  5. https://nocqua.com/faq/ ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7

  6. https://media.pelicaninternational.com/m/365c5c9bb8b709d5/original/OM_WildernessSystems_23_24__V3.pdf ↩

  7. https://eddyline.com/blogs/news/kayak-care-and-repair ↩ ↩2 ↩3

  8. https://cdn.shopify.com/s/files/1/0284/7725/9864/files/Carbonlite_Owners_Manual.pdf?v=1693257223 ↩

  9. https://www8.garmin.com/manuals/webhelp/echomapuhd/EN-US/ECHOMAP_UHD_OM_EN-US.pdf ↩ ↩2 ↩3 ↩4 ↩5

  10. https://media.pelicaninternational.com/m/3c05a975735a916d/original/IPVUE_CRANK_100_9351800178.pdf ↩ ↩2

  11. https://www8.garmin.com/manuals/webhelp/GUID-333762A2-4D98-4BBB-93EE-FD0970D1B378/EN-US/STRIKER_Cast_OM_EN-US.pdf ↩ ↩2 ↩3